ER 025T

The existing surface is clean, dry, flat and free of dirt, dust, oil, wax, mold and PROTECT-A ER 025
The surface must be free from effects that will worsen T performance.
All loose, dusty, cracked, crusted and previously painted surfaces
scraping, sanding, wire brushing and/or machine assistance (pressurized
must be cleaned with water spray or sandblasting).
At least 1500 – for washing existing surfaces on exterior surfaces with pressurized water.
There should be 2000 psi water pressure.
For metal roof surfaces, loose rust, milling, rust formations adhering to the surface
or white rust on the metal surface using the methods mentioned above.
They should be removed from the surface.
Damaged or decomposed surfaces must be repaired. Old painted surfaces and
irregularities should be sanded. until shiny surfaces become matte.
All surfaces should be primed by adding PROTECT-A ER 025 T 30% water.
APPLICATION:
PROTECT-A ER 025 T can be applied with brush, roller or airless spray machines.
Circularly in downward and upward directions before and during application.
PROTECT-A ER 025 T should be mixed.
For best results, it should be applied in two coats, leaving 4-6 hours between coats.
Do not apply to wet surfaces. This coating material is slightly damp
It can be applied to surfaces and the material can be applied to the ground on water-saturated wet surfaces.
It is not possible for it to stick.
In roll applications, the two layers to be applied should be perpendicular to each other.
(If the first coat is applied parallel to the length of the application surface, the second
The coat should be perpendicular to the length of the application surface.)
In airless spray application, spray gun nozzle diameter is 0.021” – 0.030”
Material should be pumped with the nozzle with a flow rate of 2 gallons per minute.
Surface smoothing application with a roller immediately after spray application
This application is recommended as proper adhesion will be ensured when done.
Apply when the surface and ambient temperature is between 5˚ C – 35˚ C.
Against adverse weather conditions in exterior surface applications
The application must be protected.