AR 025 ULTRA T

Surface Preparation
The existing surface is clean, dry, flat and free of dirt, dust, oil, wax, mold and PROTECT-A AR 025 LIQUID.
The surface must be free from effects that will worsen MEMBRANE performance.
Scraping all loose, dusty, cracked, crusted and previously painted surfaces,
sanding, wire brushing and/or machine assistance (pressurized water spray or
must be cleaned by sandblasting.
At least 1500 – 2000 psi water for washing existing surfaces on exterior surfaces with pressurized water.
must have pressure.
For metal roof surfaces, loose rust, mill scale, rust formations adhering to the surface or metal
white rust on the surface can be removed from the surface using the methods mentioned above.
They should be removed.
Damaged or decomposed surfaces must be repaired. Old painted surfaces and
irregularities should be sanded. until shiny surfaces become matte.
must be sanded. PROTECT-A AR 025 LIQUID MEMBRANE 30% is added to all surfaces with water.
must be primed.
APPLICATION
PROTECT-A AR 025 LIQUID MEMBRANE can be applied with brush, roller or airless spray machines.
applicable.
Circularly in downward and upward directions before and during application.
PROTECT-A AR 025 LIQUID MEMBRANE should be mixed.
For best results, it should be applied in two coats, leaving 4-6 hours between coats.
Do not apply to wet surfaces. This coating material is suitable for slightly damp surfaces.
It can be applied and the adhesion of the material to the ground on water-saturated wet surfaces.
It wouldn't be possible.
In roller applications, the two layers to be applied should be applied perpendicular to each other. (The first
If the second coat is applied parallel to the length of the application surface, the second coat is applied parallel to the length of the application surface.
must be upright.)
In airless spray application, the spray gun is used with a nozzle diameter of 0.021" - 0.030".
Material should be pumped at a flow rate of 2 gallons per minute.
When surface smoothing is applied with a roller immediately after spray application
This application is recommended as proper adhesion will be ensured.
Apply when the surface and ambient temperature is between 5˚ C – 35˚ C.
Application against adverse weather conditions in exterior surface applications
must be protected.