013 STRUCTURAL REPAIR MORTAR

Surface Preparation
All surfaces to be applied must be free of dirt, dust, oil and all contaminants, and the surface must be wetted.
and should be kept moist.
Material Preparation
Approximately 5.5 liters of water depending on the air temperature until a homogeneous mixture is obtained. 013 REPAIR
MORTAR is added and mixed with a low speed mixer (400 – 600 rpm) until there are no lumps.
After mixing, the mixture is left for 5 minutes and mixed for another 30 seconds until the product is ready for use.
is brought. The mixture in the container should be consumed within 30 minutes and if this time is exceeded, the mortar should not be used.
Application details:
Immediately before application, surfaces such as concrete and cement-based plaster should be moistened with clean water. Surface
You should wait until the water is absorbed, and care should be taken to ensure that the surface is moist, not wet, during application.
Repair mortar is applied to cracked and broken areas separated from the surface with the help of a trowel.
After application, direct sunlight, strong wind, high air temperature (above +35°C), rain and frost
It should be protected against adverse weather conditions such as
Immediately after application, before it hardens, the equipment should be cleaned with water. After the product hardens
It should then be cleaned using mechanical methods.